| Inventory | 100000 |
Product Description
Specification:
1.color :Red / White / Blue(as per sample)
2.volt: DC12v
3.long life time;
4.Rate of output workers: 3W (as 10W of the halogen bulb)
5.Operating temperature: -40 c ~ 105 c
6.Lighting dimensions: length about 3.5CM , diameter is about 2CM
Package: 100 sets (2 pieces per set with a drill)
please remark what logo do you need, thanks
[LED car logo shadow light User Manuel]
1. This product is specially designed for auto modification fans; we purpose to bring more driving fun to drivers;
2. The product can be installed at the body kit, chassis or other suitable place;
[LED car logo shadow light Installation]
This product should be installed at the bottom of the door frame and make sure the Lens is vertical with the ground
1. Pull down the inside door board first. Mark the suitable location for drilling a hole.
2. Drill the hole on the door board with supplied drill bit.
3. Insert the product from the bottom of car door, and then arrange the power cord.
4. Install the nut through the power cord upon the hole inside, tighten the nut
5. Connect the power cord.
6. Adjust the lamp projection to the suitable place.
7. Reinstall the inside door board, and check the final effect.
[LED car logo shadow light Attention]
1.We strongly suggest installing this product by Professional Automobile Modify Factory or Workshop. The manufacturers disclaim all responsibility for belongings or personal casualty caused by improper installation or misuse.
2.Our company does not responsible for the legality of installing this product, please confirm with the vehicle management department for the record before installation ;
3.Please access the positive and negative poles of the power through voltage regulator rectifier. Do NOT direct access to car battery.
