Introduction: 

This Hybrid Electric Vehicle Integrated Training System electrical lab equipments is based on the real vehicle, the vehicle system can run, starting, acceleration, deceleration, fault detection and diagnosis, fault simulation and elimination of the actual operation conditions, the real display of the vehicle system structure and principle and working process.

This Hybrid Electric Vehicle Integrated Training System electrical lab equipments is suitable for all kinds of colleges and training institutions for the practical training of vehicle theory and maintenance.

Structure: 

The real vehicle assembly, vehicle starting running all the relevant original car accessories, fault setting and eliminate system, the original car circuit board and test each system terminals, 60 ah large capacity battery, original tank car, engine acceleration mechanism, the vehicle's system control surface BanGui, movable bench, the bench power master switch, OBD diagnostic, cooling system, training guidanceBook and stand operation manual.

Each sensor and actuator installation digital display table, bench installation fuel pressure gauge and vacuum gauge, casters with locking universal, bench high temperature and rotation, etc., equipped with protective devices.

Features:

1.All systems of the car run normally. The console can be removed and the whole vehicle can run normally.

2.The fault simulation system can simulate the actual operating conditions and set up a variety of common faults in various systems of real vehicles.

3.Pointer type oil pressure gauge indicates fuel pressure value;Pointer vacuum gauge indicates vacuum pressure value.

4.The detection terminal is installed on the console panel, which can directly detect the sensors and actuators, such as resistance, voltage, current, frequency, waveform signals, etc.

5.The Hybrid electric vehicle integrated training system is equipped with the main switch of power supply, and other rotating parts of the protective cover and other safety protection devices.

6.The base part of the training system adopts the original chassis, and the surface panel cabinet is stamped and formed, and the surface adopts the paint baking process. The base of the control panel cabinet is equipped with universal self-locking caster device.